I/P Controller

I/P Controller

The optional Kinetrol I/P Controller is mounted in place of the standard diaphragm housing on the side of the AP positioner unit. The AP positioner can still be mounted in any orientation and gives an angular output position proportional to the input current control signal between 4-20mA.

Technıcal Specıfıcatıons

  • Electrical Control Signal: 4-20 mA
  • Coil Impedance: 20 ohms typical
  • Cable Entry: 16 mm conduit or gland (mini DIN plug, IP65 with Pg9 cable gland, optional 6-8 mm diameter)
  • Air Supply: 80 psi / 5.5 bar nominal
  • Air Inlet: G1/8 (equipped with 6 mm pipe diameter push-in connector)
  • Linearity: 1.5%*
  • Delay: less than 1%*
  • Sensitivity/Dead Spot: Less than 1%*
  • Feed Pressure Effect: 0.2% per psi between 80 and 60 psi
  • Air Consumption: 3.5 l/min free air max.
  • Operating Temperature Range: -20 °C to +80 °C

     

    Device quality dry, fresh air mandatory (Class 6.4.4.4 ISO8573.2001)

    • These refer to the combination of the Kinetrol actuator with the I/P controller – not just the positioner performance.

Delıvery Informatıon

Net Weight 1.20 kg

Package Size: 10x10x12 cm

Customs Tariff Code: 8479.90.00.10.00

Country of Origin: England

Documents

Kinetrol I/P Controller Datasheet

PDF Dosya

English 924 kb .PDF

Reviews

There are no reviews yet.

Be the first to review “I/P Controller”